VEXILAR FL-10 Bedienungsanleitung PDF herunterladen

Minn Kota Universal Sonar Models 01/13/04

12 - 1

Section 12.

Minn Kota Universal Sonar

Minn Kota Universal Sonar motors are serviced in the same manner as their non-Universal Sonar

counterparts. Consult the appropriate section of the Minn Kota Service Manual for the step-by-step

trouble shooting and repair procedures applicable to the motor being serviced.

This trouble-shooting section DOES NOT take the place of the specific sonar unit’s trouble-

shooting guide. Consumers should consult their owner’s manual for their sonar unit for all

depth finder problems.

A capacitance meter and a good quality multi-meter (VOM) are needed to test the transducer and

cable installed in the Minn Kota Universal Sonar Motors. We recommend using a Waveteck

Meterman model CR50. This meter can be purchased at most major electronics suppliers. (Some

better multi-meters may also be capable of measuring capacitance.)

Please note that the transducer is held into the Minn Kota lower unit with tamper-resistant, torx-head

screws (T-15). These are torqued to 12-15 inch/pounds. The Minn Kota factory warranty will be

voided if the consumer tampers with these screws!

Case I. Sonar display blacks out while trolling motor is running.

(This case refers to suggestions the customer should try with the sonar unit and with his boat wiring.)

Step 1. Consumer should refer to the user’s manual for the sonar display configuration options. (Many sonar

displays have noise reduction options within their menus.)

Step 2.

Reduce gain of sonar display until an adequate display is visible.

Step 3. Determine wiring configuration of the boat

A. If the power leads of the sonar display are routed next to the power leads for the trolling

motor for a great distance, separate the leads as much as possible.

Case II. Sonar unit not receiving bottom reading.

(Be sure sonar unit is on current list of models compatible with Universal Sonar) see page 12-4

Step 1. Customer should first refer to the sonar unit’s owner’s manual for its specific trouble-shooting guide.

A. If customer still has the original transducer that came with the sonar unit; he can use this to

determine if the sonar unit faulty or if the Universal transducer is at fault.

A-1. If sonar works properly with original transducer; proceed to Step 2.

A-2. If sonar still does not receive bottom reading, problem lies in sonar unit.

Step 2.

Verify capacitance measures according to the following picture (Figure 1, page 12-3) and chart (Chart

A, page 12-3)

A. Measure the capacitance of the transducer at the extension cable plug end that exits the motor

coil cord (PD/AP and Genesis models) or footpedal (Maxxum foot-control models) using

your capacitance meter as per

Figure 1. Touch the red and black probes from your

capacitance meter to the correct pins on the plug (transducer + and -). For proper orientation,

be sure the connector key (ridge) is at the top of the plug as in

Figure 1, page 12-3 (just above

and between the red and black probes).

1 2 3 4 5 6 ... 14 15

Inhaltsverzeichnis

Seite 1 - Minn Kota Universal Sonar

Minn Kota Universal Sonar Models 01/13/04 12 - 1 Section 12. Minn Kota Universal Sonar Minn Kota Universal Sonar motors are serviced in the same

Seite 2

Minn Kota Universal Sonar Models 01/13/04 12 - 10 Humminbird / Zercom (Techsonic) Adapter Cable Item No. 1852053 (MKR-US-4)

Seite 3 - (ridge)

Minn Kota Universal Sonar Models 01/13/04 12 - 11 Lowrance / Eagle Adapter Cable (gray) Item No. 1852054 (MKR-US-5)

Seite 4

Minn Kota Universal Sonar Models 01/13/04 12 - 12 Lowrance / Eagle Adapter Cable (black) Item No. 1852055 (MKR-US-6)

Seite 5

Minn Kota Universal Sonar Models 01/13/04 12 - 13 Vexilar Adapter Cable Item No. 1852056 (MKR-US-7)

Seite 6 - Part No. 2211400 and 2211405

Minn Kota Universal Sonar Models 01/13/04 12 - 14 Humminbird (Techsonic) Adapter Cable Item No. 1852057 (MKR-US-8)

Seite 7 - Item No. 1852050 (MKR-US-1)

Minn Kota Universal Sonar Models 01/13/04 12 - 15 Lowrance / Eagle Adapter Cable Part No. 1852058 (MKR-US-9)

Seite 8 - Item No. 1852051 (MKR-US-2)

Minn Kota Universal Sonar Models 01/13/04 12 - 2 A-1. If the capacitance falls within the minimum and maximum allowable limits (per Chart A) for

Seite 9 - Item No. 1852052 (MKR-US-3)

Minn Kota Universal Sonar Models 01/13/04 12 - 3 connector key (ridge) Figure 1 NOTE: you cannot order transducer replacements by the P/N

Seite 10 - Item No. 1852053 (MKR-US-4)

Minn Kota Universal Sonar Models 01/13/04 12 - 4 With the proper Minn Kota adapter cable the Universal Sonar transducer will be compatible with th

Seite 11 - 12 - 11

Minn Kota Universal Sonar Models 01/13/04 12 - 5 Minn Kota Universal Sonar Transducer & Cable Assembly Note: Take transducer capacitance read

Seite 12 - Item No. 1852055 (MKR-US-6)

Minn Kota Universal Sonar Models 01/13/04 12 - 6 Minn Kota Cable Extension Part No. 2211400 and 2211405

Seite 13 - Item No. 1852056 (MKR-US-7)

Minn Kota Universal Sonar Models 01/13/04 12 - 7 Garmin Adapter Cable Item No. 1852050 (MKR-US-1)

Seite 14 - 12 - 14

Minn Kota Universal Sonar Models 01/13/04 12 - 8 Bottom Line 9-Pin Adapter Cable Item No. 1852051 (MKR-US-2)

Seite 15 - Part No. 1852058 (MKR-US-9)

Minn Kota Universal Sonar Models 01/13/04 12 - 9 Bottom Line 7-Pin Adapter Cable Item No. 1852052 (MKR-US-3)

Weitere Dokumente für Nein VEXILAR FL-10

Um das Dokument anzuzeigen VEXILAR FL-10 Installationshandbuch

VEXILAR FL-10 Installationshandbuch (52 Seiten)

Um das Dokument anzuzeigen VEXILAR FL-10 Bedienungsanleitung

VEXILAR FL-10 Bedienungsanleitung (7 Seiten)

Kommentare zu diesen Handbüchern

Keine Kommentare

VEXILAR FL-10 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Nein VEXILAR FL-10 herunter. Section 12. Minn Kota Universal Sonar Benutzerhandbuch

Inhaltsverzeichnis

Weitere Dokumente für Nein VEXILAR FL-10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein VEXILAR FL-10