Vexilar FL-8SLT Bedienungsanleitung PDF herunterladen (Seite 4)

INSTALLATION

To make the FL-8SLT work, you must provide the unit with power

and mount the transducer in an appropriate location.

UNIT INSTALLATION

Find a convenient place to

mount the unit. This may include

a boat seat, deck, dash, or a

portable case. Make sure that there

is plenty of room for the unit to tilt

and/or swivel freely without the

cables binding behind the unit.

Once you have found a spot,

remove the unit from the gimbal

bracket. Securely attach the brack-

et to the mounting surface.

POWER CONNECTION

Plug the flat 3 pin connector into the back of the unit. Find the clos-

est source of 12 volts and run the cord to it. Keep the cord away from

sharp metal edges and avoid tight places where the cord may get crushed.

Connect the red wire to positive and the black wire to negative or ground.

If the cord provided is not long enough, more can be added. Use 18 gauge

wire minimum. It is recommended that a 1 amp in-line fuse be placed

in the positive line as close to the power source as possible to protect

against any shorts in the wiring.

1 2 3 4 5 6 7 8 9 ... 27 28

Keine Kommentare

Vexilar FL-8SLT Bedienungsanleitung Seite 4