Vexilar FL-8SLT Bedienungsanleitung PDF herunterladen (Seite 6)

PUCK STYLE TRANSDUCERS

There are three ways in which a Puck Style trans-

ducer can be mounted. It can be mounted In-Hull, on

an electric trolling motor, or portable (with a suction

cup or on an arm of some type).

IN-HULL MOUNTING

This method, gluing the transducer to the hull, gets the same results

as if you were using the High Speed transducer only there are no holes

to drill in the boat and there is no transducer on the transom to get dam-

aged by impact.

Finding the best location for the transducer before mounting is crit-

ical. Choose a flat smooth spot near the center of the bilge and near the

back of the boat. It is a good idea to make a "test run" before you per-

manently install the transducer to make sure that you can indeed get a

reading through your hull, and when the boat is on plane. Put about a

half inch of water in the bilge and hold the transducer in the intended

location. Move the transducer around until you get the best reading.

Mark the spot.

To install the transducer clean the spot of mud and oil. Using an

epoxy or silicone glue make a puddle about the same diameter as the

transducer on the hull. Place the transducer in the glue. Press it down

firmly, gently twisting it back and forth, making sure that there are no

air bubbles in the glue between the transducer and the hull. Let the glue

dry completely before turning the unit on.

Run the transducer cord up to the unit taking the same care as you

did when you ran the power cord. Plug the transducer connector into

the back of the unit and screw the retaining ring down tight.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Keine Kommentare

Vexilar FL-8SLT Bedienungsanleitung Seite 6